Shank Connector (for Accuflex Bev Seal)

(6 reviews) Write a Review

Make installing Accuflex Bev Seal tubing a breeze on your kegging system with these connectors!  Simply push the Accuflex Bev Seal Ultra tubing into the fitting, and screw it on the end of your shank (Birdman Brewing Item SH-4SS).  No extra parts required.  Fitting comes with integrated washer for leak proof seal.  

  • Gray acetal copolymer construction
  • Nitrile O-rings
  • FDA approved materials
  • NSF Certified 51 & 62
  • 5/16 in. x 5/8 in. FPT




6 Reviews Hide Reviews Show Reviews

  • 5
    Easy to install

    Posted by Ryan on 31st Oct 2019

    Incredibily easy to install. Threaded onto shank and pushed in tubing (Accuflex Bev-Seal Ultra Barrier Tubing 3/16" ID) and was drinking beer immediately.

  • 5
    Wish I realized these existed when I first bought accuflex

    Posted by Ricky on 23rd Sep 2016

    $5 worth of extra-strength headache relief

  • 5
    Must need for Accuflex

    Posted by Bukit on 1st Dec 2015

    If you're using Accuflex in your system, as you should, you'll definitely want to buy the shank connectors. Just slide the Accuflex in and your done. I've never had any leaks or other issues. Just be careful to ensure your O-ring remains in place. I've had difficulty finding similar replacements. Accuflex is great tubing and these are the best connectors to use with it.

  • 5
    Must have for install/uninstall

    Posted by Tim on 4th Feb 2015

    Cant imagine using the hose without these fittings. easy to push and pull hoses on and off for cleaning/swapping/installing etc.

  • 5
    Make your life easier

    Posted by Tom on 1st Aug 2014

    Buy these, the quick disconnect side, and accuflex tubing and make your life that much easier. I've had no leaks using this product and can assemble a line in about 45 seconds!

  • 5
    Don't use any other method

    Posted by Jay on 17th Apr 2014

    If you're using bev-seal tubing you've got to use this. I tried pushing, heating, stretching the tubing before to get it over barb connections but it was always very difficult and often a slow drip would develop. Not with these connections. Cut your length of tubing and push it into the connection, done. That simple. I did 5 faucets in about 20 minutes with these connections and haven't had a single drip.